SERVICE SUPPORT DIVISION Address: 2050 W. Responsible Party Name: PIONEER ELECTRONICS (USA), INC. Refer all servicing to qualified personnel.įEDERAL COMMUNICATIONS COMMISSION SUPPLIER'S DECLARATION OF CONFORMITY Product Name: DVD RDS AV RECEIVER To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. This product is a Class 1 laser product classified under the safety standard, IEC 60825-1:2014, and contains a class 1M laser module. THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT WILL INCREASE EYE HAZARD. USE OF CONTROL OR ADJUSTMENT OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. – Consult the dealer or an experienced radio/TV technician for help. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Increase the separation between the equipment and receiver. – Reorient or relocate the receiving antenna. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
–NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. –Alteration or modifications carried out without appropriate authorization may invalidate the user’s right to operate the equipment.
–This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. But it is desirable that it should be installed and operated keeping the radiator at least 20 cm or more away from person’s body (excluding extremities: hands, wrists, feet and ankles). This equipment has very low levels of RF energy that it deemed to comply without maximum permissive exposure evaluation (MPE). –This equipment complies with FCC/ISED radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the ISED radio frequency (RF) Exposure rules. –The Bluetooth antenna cannot be removed (or replaced) by user. (2) this device must accept any interference, including interference that may cause undesired operation of this device. Operation is subject to the following two conditions: (1) this device may not cause interference, and –This device contains licence-exempt transmitter(s)/receiver(s) that complies with Part 15 of FCC Rules and Innovation, Science, and Economic Development Canada licence-exempt RSS(s).
0 kommentar(er)
